ページを印刷する
Now work on the pedal on your right. Obviously there will only be one available conrod now. The
one that is CLOSEST to the DRIVE WHEEL. Push the green joiner through the hole in the pedal end
into the right hand pedal. It should protrude through the bottom of the pedal about 2mm. Check
the alignment of the rod end in the crank assembly as shown in the images below. You may need to
twist the green joiner in the pedal to correct the alignment. When the rod end is aligned correctly -
parallel with the face of the drive wheel - screw the 25mm screw into place. The screw should only
be tightened until the head just touches the side of the pedal. DO NOT OVERTIGHTEN!
8a
8d
CORRECT
EXTRA
If you are not certain of the connection arrangement, here is a
full description. Place the wheel directly in front of you so you are
looking at the crank assembly attached to the drive wheel. The
rubber joiner that is on the conrod that is closest to you goes into
the hole in the pedal on your left. The joiner on the conrod that is
furthest from you goes into the hole in the pedal that is on your
right.
8f
8b
INCORRECT
9
8c
8e
majacraft