- ページ 8

回転する車輪 Majacraft Suzie ProfessionalのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Majacraft Suzie Professional 12 ページ。
Majacraft Suzie Professional にも：マニュアル (12 ページ)

ページを印刷する

Fit the green joiners in the wooden footmen to the pedals. We leave a mark on one conrod (a #1 on

the bottom end) and the right pedal (#1 by the screw hole) to ensure that each conrod is attached to

the correct pedal.

Starting with the right pedal (it will be on your left if you are facing the drive wheel), remove the

gold 25mm screw from the side of the pedal. Choose the conrod with the #1 stamped on the bottom

and push the green joiner through the hole in the pedal. It should protrude through the bottom of

the pedal about 1mm-2mm. Check the alignment of the outer rod end in the crank assembly. When

the rod end is aligned correctly, screw the 25mm screw back into place. The screw should only be

tightened until the head just touches the side of the pedal. DO NOT OVERTIGHTEN!

Now the left pedal (it will be on your right if you are facing the drive wheel), remove the gold 25mm

screw from the side of the pedal. Choose the remaining conrod and push the green joiner through

the hole in the pedal. It should protrude through the bottom of the pedal about 1mm-2mm. Check

the alignment of the rod end in the crank assembly as shown below. When the rod end is aligned

correctly, screw the 25mm screw back into place. The screw should only be tightened until the head

just touches the side of the pedal. DO NOT OVERTIGHTEN!

CORRECT

INCORRECT

majacraft