ページを印刷するInstruction Manual
Troubleshooting
PROBLEM
Indicator light will not turn on and unit
will not heat
Heating indicator is not on.The
temperature is not increasing
Power indicator is on but the desired
temperature is not reached
Temperature control is normal but
indicator is not on
Temperature indicator is on.But heater
tube is not hot
Temperature can not be controlled
Do not use the machine if any of the above occur.
Any troubleshooting corrections should be performed by a qualified technician
Daily Check
Before using the machine, visually inspect for any signs of damage or frayed power cord. Be certain
machine is on a level countertop.
After turning it on, check for anything unusual before you use it.
Inspect the machine every day before using. If there is any question about operation, do not use
CAUSED
Plug not properly in-serted
On&Off power switch broken
Electric heater tubes is not
properly connected.
Heater is defective
Temperature controller is burned
out
Indicator light is burned out
Temperature limiter has tripped
Temperature Limiter is out of
order
SOLUTION
Plug unit in
Replace power switch
Tighten both sides of electric heater
Replace electric heating tube.
Replace Thermostat Control
Replace indicator.
Reset over heating protecting button
by hand on bottom of electrical box
Replace temperature limiter/Rest
Button
5