- ページ 13
ネイルガン CentralPneumatic 69927のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。CentralPneumatic 69927 20 ページ。 Framing nailer 28 angle
ページを印刷するLoading the Tool
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING:
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
Note: Make sure nail type and angle are correct for nailer.
1. Pull Pusher all the way to the rear of Magazine
until it is held in place by the Pusher Lock.
General Operating Instructions
1. Before each use, test the tool as
directed in the prior section.
2. If an automatic oiler is not used, add a few
drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
WARNING! TO PREVENT
SERIOUS INJURY: Keep second hand
away from tool discharge area,
especially if holding workpiece.
Tool applies extreme force to fastener,
and fasteners may deflect or fire in an
unexpected direction.
CAUTION! TO PREVENT INJURY: Do not hold tool
near body while firing. Tool recoil can cause injury.
3. Position tool at desired fastener location and depress
the Safety Nosepiece fully against the workpiece.
Squeeze the trigger to fire a fastener.
Note: PREVENT DOUBLE FIRING,
allow the tool to recoil from the workpiece,
do not force it against the workpiece.
4. Firing multiple fasteners
using contact trip (bump fire) mode:
Squeeze and hold trigger, then push safety nosepiece
to fire one fastener, move and push safety nosepiece
again to fire additional fasteners.
5. To change firing depth: Disconnect Air Supply
and keep Safety Nosepiece pointed away.
Loosen the Depth Adjustment Screw,
adjust the Safety Nosepiece, and retighten the
Screw to control the firing depth. See Figure D.
Item 69927
69928
For technical questions, please call 1-800-444-3353.
2. Orient a strip of nails with the tips down and
drop the strip of nails into Magazine.
3. Pull Pusher back, release Pusher Lock, and
allow Pusher to slide forward against strip of nails.
Depth
Adjustment
Screw
Safety
Nosepiece
Figure D: Depth Adjustment
6. If, at the maximum depth setting, the tool requires
more force to accomplish the task, verify that the tool
receives sufficient, unobstructed airflow (CFM) and
increase the pressure (PSI) output of the regulator
up to the maximum air pressure rating of this tool.
CAUTION! TO PREVENT INJURY FROM TOOL OR
ACCESSORY FAILURE:
Do not exceed the tool's
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
Note: The nailer will stop firing when it is empty.
7. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Change the Mode Switch to
d. Attempt to fire the Tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
e. Release the trigger again.
f. Clean external surfaces with clean, dry cloth.
g. Store indoors out of children's reach.
setting.
Page 13