- ページ 5

ヒーター BriskHeat Custom SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。BriskHeat Custom Series 8 ページ。 Silicone rubber heating blankets

ページを印刷する

Hardware:



Junction Box



Wire Ties



Mounting Hardware



Temperature controller and sensor



Silicone RTV

MOUNTING YOUR HEATING BLANKET

Your silicone rubber heating blanket can be mounted on both flat and curved

surfaces. However, do not allow your heater to exceed the maximum "bend

radius". The typical bend radius is approximately 2" (51mm). To determine the bend

radius, slowly bend the heater until it begins to crease or fold. The point prior to

creasing is the bend radius. Your heater may be more flexible in one direction than

the other, however, the heater should be installed with the wires exiting the

bottom if in an outdoor application.

Your heater can be attached to the surface using:

• Factory applied PSA (pressure sensitive adhesive)

• Factory supplied mechanical fasteners

• Factory supplied or recommended mechanical clamping devices

• High-temperature adhesive tape that will not damage the heater

• Thin layer of RTV

For all installations, regardless of adhesion method:

1. For proper temperature control, place the thermocouple, RTD, or other sensing

device, so that it touches the edge of the heating blanket.



Sensor must be in close proximity to the heater to prevent

overheating.



If heating blanket is installed on a vertical surface, place sensor

directly on lower edge of heating blanket since heat naturally rises.



Sensor should be connected in accordance with instructions provided

with temperature controller.



Secure with one strip of aluminum adhesive tape.

2. Ensure heater is in contact with the surface to be heated. If air gaps are

present, heat transfer will decrease and there is a potential to overheat the

heating blanket. Use a medium to hard roller to eliminate trapped pockets of air.

Do not wrap the heater over itself or allow it to contact a

second heater.

BriskHeat

SRL, SRP, SRMU, SRX, Custom Series

Silicone Rubber Heating Blankets



Insulating material



High-temperature adhesive tape

(part # AA2180)



Plug if connecting heater to a

receptacle rather than hard wiring to

a temperature controller or junction

box