- ページ 3

室内暖炉 Majestic FSUV20のPDF 設置および住宅所有者向け操作説明書をオンラインで閲覧またはダウンロードできます。Majestic FSUV20 16 ページ。

ページを印刷する

Design-certiﬁed to ANSI Z21.11.2a 2003. Gas-Fired Room

Heaters — Vol. II, Unvented Room Heaters.

This gas room heater should be installed by a qualiﬁed

installer in accordance with local building codes and with cur-

rent National Fuel Gas Code. ANSI Z223.1/NFPA 54.

In the Commonwealth of Massachusetts, all gas ﬁttings

and installation of this heater shall only be done by a

licensed gas ﬁtter or licensed plumber.

This appliance may be installed in an aftermarket,

permanently located, manufactured (mobile) home,

where not prohibited by local codes.

This appliance is only for use with the type of gas

indicated on the rating plate. This appliance is not

convertible for use with other gases.

This heater shall not be installed in a conﬁned space or

unusually tight construction unless provisions are provided for

adequate combustion and ventilation air.

The National Fuel Gas Code, ANSI Z233.1/NFPA 54 deﬁnes

a conﬁned space as a space whose volume is less than 50

cubic feet per 1,000 Btu per hour (4.8m

gregate input rating of all appliances installed in that space

f i r e - p a r t s . c o m

and an unconﬁned space as a space whose volume is not

less than 50 cubic feet per 1,000 Btu per hour (4.8 m

kw) of the aggregate input rating of all appliances installed

in that space. Rooms communicating directly with the space

in which the appliances are installed, through openings not

furnished with doors, are considered a part of the unconﬁned

space.

WARNING: If the area in which the heater may be operated

is smaller than that deﬁned as an unconﬁned space or if the

building is of unusually tight construction, provide adequate

combustion and ventilation air by one of the methods, de-

scribed in the National Fuel Gas Code,

ANSI Z 223.1/NFPA 54, Section 5.3 or applicable local codes.

Unusually tight construction is deﬁned as construction where:

a) Walls and ceilings exposed to the outside atmosphere have

a continuous water vapor retarder with a rating of 1 perm

(6 x 10-11 kg per pa-sec-m2)

b) Weather stripping has been added on openable windows

and doors, and

c) Caulking or sealants are applied to areas such as joints

around window and door frames, between sole plates and

ﬂoors, between wall-ceiling joints, between wall panels, at

penetrations for plumbing, electrical, and gas lines, and at

other openings.

Fireplace screen (when equipped) must be closed

while the appliance is in operation.

WARNING: Do not install televisions or other elec-

tronic devices above this ﬁreplace unless approved

by the electronics manufacturer.

Proposition 65 Warning: Fuels used in gas, woodburn-

ing or oil ﬁred appliances, and the products of combustion

of such fuels, contain chemicals known to the State of

California to cause cancer, birth defects and other repro-

ductive harm.

California Health & Safety Code Sec. 25249.6

10001784

Installation & Operating Instructions

per kw) of the ag-

FOR SAFE INSTALLATION AND OPERATION OF YOUR

VENT-FREE ROOM HEATER PLEASE NOTE THE FOL-

LOWING:

1. This heater gives off high temperatures and should be lo-

cated out of high trafﬁc areas and away from furniture and

draperies.

2. Children and adults should be alerted to the hazards of the

high surface temperatures of this heater and should stay

away to avoid burns or ignition of clothing.

3. Children should be carefully supervised when they are in

the same room as your heater.

4. Under no circumstances should this heater be modiﬁed.

Parts removed for service should be replaced prior to

operating this heater again.

5. Installation and any repairs to this heater should be carried

out by a qualiﬁed service person. A professional service

person should be contacted to inspect this heater annually.

Make it a practice to have all of your gas heaters checked

annually. More frequent cleaning may be required due to

excess lint and dust from carpeting, bedding material, etc.

6. Control compartments, burners and air passages in this

heater should be kept clean and free of dust and lint. Make

sure that the gas valve and pilot light are turned off before

you attempt to clean this unit.

7. Under no circumstances should any solid fuels (wood,

per

coal, paper or cardboard, etc.) be used in this heater.

8. Keep the area around your heater clear of combustible

materials, gasoline and other ﬂammable vapor and liquids.

This heater should not be used as a drying rack for cloth-

ing, nor should Christmas stockings or decorations be

hung in the area of it.

9. Whether the heater is installed directly on carpeting, vinyl

tile or any combustible material other than wood, this

heater must be installed on a metal or wood panel extend-

ing the full width and depth of the heater.

10. Do not install heater in bedroom or bathroom.

Please Review the Following Carefully

It is normal for ﬁreplaces fabricated of steel to give

off some expansion and/or contraction noises during

the start up or cool down cycle. Similar noises

are found with your furnace heat exchanger or car

engine.

It is not unusual for your gas ﬁreplace to give off

some odor the ﬁrst time it is burned. This is due to

the curing of the paint and any undetected oil from

the manufacturing process.

Please ensure that your room is well ventilated

- open all windows.

Whenoperating the ﬁreplace for the ﬁrst time it is

recommended that you burn your ﬁreplace for a

least six (6) hours the ﬁrst time you use it. If the

optional fan kit has been installed, place the fan in

the "OFF" position during this time.

FSUV20/30 Vent Free Gas Heater

Important: