ページを印刷する
Installation
Basin Mixer / 1 Hole Bath Filler/
Tall Basin Mixer
1. Screw the flexi tails into the bottom of
the tap body and tighten by hand only
(DO NOT OVERTIGHTEN).
2. Feed the flexi tails through the hole,
in the basin / bath, ensuring the washer
is fitted between the body and the basin/
bath.
3. Screw the fixing rods into the bottom
of the tap body. Slide 'C' shaped rubber
washer and 'C' shaped metal washer onto
the fixing rods up to the underside of the
basin.
4. To secure the tap in place tighten the
fixing nuts onto the fixing rods until they
are fully tightened against the 'C' shaped
metal washer, the fixing nuts can be
tightened with a suitable spanner.
5. Connect the flexi tails to the hot and
cold water supplies.
6. Fit the clicker waste ensuring the
rubber washer is fitted between the basin
and the waste. Place the other rubber
washer under the basin and secure in
place by tightening the backnut. In order
to fill the basin, the button in the middle of
the waste needs to be pressed down. To
release the water, press the button again.
7. Turn on both water supplies, operate
the handle in both directions, letting the
water flow for a few mninutes to flush
through the system.
8.Check all joins and connections for any
leaks.
Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.
9