- ページ 8

配管製品 Bristan Hourglass HOU BSM CのPDF 取付説明書＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bristan Hourglass HOU BSM C 20 ページ。

Installation Continued

Basin Mixer

1. Identify all components are present prior to starting installation using the diagram below.

2. Fit the mixer body (7) to the basin ensuring the O-Ring (9) is fitted between the basin and

mixer body (7)

3. From the fixing kit (10), screw the 2 fixing rods into the bottom of the mixer body (7). Push

the C shaped rubber and metal washers onto the threaded rods and tighten by screwing the

fixing nuts accordingly

4. Screw in (by hand only) the flexible connecting pipes (11) to the mixer body (7), (DO NOT

OVERTIGHTEN) and connect the hot and cold water supplies

5. Fit the clicker waste (11) to the basin, ensuring a rubber washer is fitted between the basin

and waste. Use a pure silicon sealant where necessary. Place the other rubber washer under

the basin and secure in place by tightening the backnut. In order to fill the basin, push down

the middle of the waste. To release the water, press the middle again

6. To operate the tap, lift the handle up and turn in both directions. Let the water flow for a few

minutes to check all joints and connections for leaks.

1. Grub Screw Cap

2. Grub Screw

3. Handle

4. Shroud

5. Cartridge Retaining Nut

6. Cartridge

7. Mixer Body

8. Anti-Splash

9. O-Ring

10. Fixing Kit

11. Flexible Tails

12. Clicker Waste (Not Shown

) x1