- ページ 2
配管製品 Bristan Jute JU BSM E8 CのPDF 取付説明書＆内容物リストをオンラインで閲覧またはダウンロードできます。Bristan Jute JU BSM E8 C 2 ページ。 Bath shower mixer
ページを印刷する
WATER PRESSURE
This mixer is suitable for use at all supply pressures. However for optimum use,
both the hot and cold supplies should be reasonably balanced.
If the fitting is installed at low pressure (tank fed), then the minimum height from the
highest installed position of the showerhead to the underside of the cold tank should
be 1 metre to ensure adequate shower performance.
This mixer should be installed in compliance with Water Regulations. For further
details contact your Local Water Authority.
CONTENTS
1. Mixer Body
(x1)
2. Handset
(x1)
3. Diverter Knob
(x1)
4. Wall Bracket
(x1)
5. Shower Hose
(x1)
6. Sealing Washer
(x2)
7. Gasket
(x1)
8. Backnut
(x2)
a. Valve
(x2)
b. Handle
(x2)
Please Note:
In the unlikely event you find a part missing please contact our Customer Service
Help line on 0844 701 6273 or email [email protected] for immediate despatch
of part.
2
INSTALLATION
1. Identify all components and check for completeness, particularly before arranging
fitting.
2. Install the mixer body (1) to the bath using the gasket (7) and backnuts (8)
provided.
3. Fit the hose (5) to the mixer (1) and the handset (2) using the small sealing
washers (6).
Prior to drilling into walls, check there are no hidden
electrical wires, cables or water supply pipes with the aid
of an electronic detector. If you use power tools do not
forget to:
Wear eye protection
•
Unplug equipment after use
•
4. Fix the wall bracket (4) to the wall ensuring that the handset (2) will reach it.
5. Connect the hot and cold water supplies and turn water supplies on.
6. Fully open the valves (a) by turning handles (b), letting it run for a few minutes to
check for leaks.
7. Operate the mixer in both bath and shower mode. To switch from bath to shower
mode, pull the diverter knob (3) up. After use, the mixer automatically reverts to the
bath filling mode.
8. See over the page for aftercare instructions.
MAINTENANCE
If the fitting begins to drip:
1. Turn off the water supply.
2. Remove grub screws from rear of handle and then remove handle (b) by pulling
from valve (a).
3. Using a suitable spanner, remove valve. Once removed, carefully clean seating,
rubber washer and ceramic disc.
4. Replace all of the above then turn on the water supply.
5. If problem persists contact our helpline quoting the product code.