- ページ 3

楽器アンプ Aguilar DB 750のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aguilar DB 750 6 ページ。 Tube bass head

Features:

Active/Passive inputs:

Start by using the passive input. If your bass's output distorts the input section, switch to the

active position. In the active input, a 10 db pad in the signal path will remedy the situation.

Volume pot:

This pot controls the gain of the preamp section. Clean sounds are usually achieved by setting the

input gain around 11 or 12 o'clock. A little bit of musical distortion will occur if set past one or

two o'clock.

Equalization:

Treble:

Tube driven shelving type, boosts up to 12 db. The center frequency is set at 4 kHz.

Bass:

Tube driven shelving type, boosts up to 12 db. The center frequency is set at 40 Hz.

Midrange:

Tube driven shelving centered at 400 Hz.

Deep Switch:

The deep switch adds 3db of broadband boost at 30 Hz.

Bright Switch:

This switch is passive RC pre-emphasis circuit at 5-7 kHz. The bright switch will add a brighter

timbre to the entire range of your bass.

Effects Loop:

The Send pot is push/pull for line or instrument level. This allows you to use a studio effects unit

(line level) or a stomp box (requires instrument level) in the FX loop. Adjust the amount of send

so as to get maximum performance from your effects unit.

The parallel/series pot is push/pull for parallel or series operation. In the parallel mode affected

signals are mixed to the dry sound. In series mode the entire sound of your bass is processed by

the effects in the loop. The amount of effects can be adjusted with the return pot. If you pull the

return pot out for series operation without any effects plugged in the loop, the loop will be open

and no sound will result.