- ページ 4

楽器アンプ Aguilar DB 751のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aguilar DB 751 6 ページ。 Hybrid bass head

FX Send:

Sends the signal to your effects units. Connect the input of your effects unit to this jack

FX Return:

Returns the signal from your effects units to the amplifier.

Connect the output of your effects unit to this jack.

Effects Loop:

The "Send" knob is push/pull for selecting line or instrument level. This allows you to

use a studio effects unit (line level) or a stomp box (requires instrument level) in the FX

loop. Adjust the amount of "Send" so as to get maximum performance from your effects

unit and the "Return" to get the right amount of effected signal.

The "Return" knob is push/pull for parallel or series operation. In parallel mode, the

effected signal is mixed to the dry sound. In series mode, the effects in the loop will

process the entire signal. The amount of effects can be adjusted with the return knob. If

you pull the return knob out for series operation without any effects plugged in the loop,

the loop will be open and no sound will result.

XLR Balanced Output:

Use the Pre-EQ setting in a concert situation where the sound engineer is taking a signal

into the house-mixing console. The engineer is now getting their feed before the preamp

stage, which allows them to use appropriate EQ for the venue. The EQ on stage will still

be controlled by your settings. If the engineer wants your EQ settings included in the

mix, set the control to Post EQ and your settings on stage will be sent to the house.

The D.I. output is –32dB. This level is the correct output for a signal going into the

preamp on a mixer. Our balanced output uses the highest quality Jensen output

transformer. If you hear any ground noise, change the position of the ground lift switch

under the output

Footswitch:

Use the optional Aguilar footswitch to mute the signal for silent tuning.