- ページ 6

キッチン家電 AIRFLO AFS140のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AIRFLO AFS140 7 ページ。 Hand held steamer

ページを印刷する

the Boiler cap is removed.

Steam cleaning

NOTE: Before operating, make sure all desired accessories are connected and Boiler is ﬁlled with the

correct amount of water.

1. For ﬁrst-time use, remove protective plastic cover that is shipped on electrical plug. Plug power

cord into a convenient 3-prong electrical outlet. Heating Indicator Light will illuminate to show

that unit is receiving power and Boiler has started to heat.

CAUTION: This unit uses a grounded (3-prong) electrical plug.

3-prong electrical outlets.

Do not attempt to alter plug or circumvent this safety feature in any

way.

2. After approximately 3 minutes, Heating Indicator Light will turn off. This indicates that Boiler is

fully heated, and unit is ready to begin steaming.

NOTE: Heating Indicator Light may cycle off and on during use, accompanied by a slight

temporary drop in steam pressure – this is a normal part of operation, as the Boiler works to

maintain a steady optimal temperature.

3. Point Jet Nozzle (and any connected accessories) towards surface you wish to steam, and press

Steam Trigger. Hold Trigger down for a continuous ﬂow of steam.

CAUTION: Always be sure that Jet Nozzle and other accessories are pointed in a safe direction

(away from yourself, other people, pets, and plants) before pressing Steam Trigger.

NOTE: When steaming any surface for the ﬁrst time, it is recommended that you consult the

manufacturer's guidelines for material being steamed. For items in question, test steam on an

inconspicuous area before proceeding.

4. Using a slight back-and-forth motion over the area you are steaming will enhance the cleaning

process, as will scrubbing the area (if a Brush is connected).

cloth to remove loosened dirt and grime.

CAUTION: Wiping an area while it is still wet is recommended, but use care when wiping surfaces

such as metal that may still be hot.

5. To effectively kill bacteria and other microorganisms, hold Jet Nozzle (and any connected

accessories) approximately 1/2 inch from surface and press Steam Trigger. Keep Trigger pressed

and concentrate steam on the same spot for at least 5 seconds.

6. At its maximum capacity (6 oz. / 180 ml.), the Boiler will provide approximately 8 minutes of

continuous steam. If you wish to continue steaming, refer to FILLING BOILER procedure. Be sure to

note Reﬁlling Boiler section at bottom of page.

7. Once you are ﬁnished using your Hand Held Steamer, immediately unplug power cord from

electrical outlet. Refer to Storage & Care guidelines for proper cleaning and storage procedures.

Proper storage

Preparing your Hand Held Steamer for storage is quick and simple. When you have ﬁnished your

Use only in properly installed

steaming tasks, follow the steps listed below.

loosely replace Boiler Cap.

Care and maintenance

A common maintenance need for steam appliances is the removal of build-up caused by mineral

content in water. This mineral build-up may limit the effectiveness and reduce the life of your

steamer.

Wipe steamed areas with a clean

your steamer. If you are unable to use distilled water, it is recommended that the following

procedure be followed monthly to help remove any mineral build-up:

1. Unplug power cord from electrical outlet.

2. Allow unit to cool (30 minutes for complete cooling).

3. Press and hold Steam Trigger to release all remaining steam pressure.

4. Unscrew and remove Boiler Cap. Drain all remaining water from Boiler into a sink or tub, then

NOTE: Do not overtighten Boiler Cap when storing, as this may make it difﬁcult to remove during

next use.

5. Loosely bundle power cord, and store your unit in a cool dry location.

The best way to minimize mineral build-up is to use distilled or de-mineralized water when using

1. Unplug power cord from electrical outlet.

2. Allow unit to cool (30 minutes for complete cooling).

3. Press and hold Steam Trigger to release all remaining steam pressure.

4. Unscrew Boiler Cap and drain all remaining water from Boiler into a sink or tub.

5. Unscrew and remove Boiler Cap, and drain any remaining water from Boiler into a sink or tub.

6. Fill Measuring Cup with 6 oz. (180 ml.) distilled vinegar. Carefully pour vinegar into Boiler.

7. Slowly shake or move unit around to agitate vinegar.