- ページ 2
キッチン＆ランプ; バス備品 Bristan GWF BF CのPDF 取付説明書＆ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bristan GWF BF C 2 ページ。
ページを印刷する
Maintenance - Valve Cleaning
1
2
Remove any O-rings, soak the
valve in de-scaler and wash
off in clean water. Examine all
Remove the cap and
loosen the grub screw.
seals and replace if needed. Use
2.5
WRAS approved silicon based
Remove the handle.
mm
grease on all seals.
General Cleaning
Your fitting has a high quality finish and should be treated with
care to preserve the visible surfaces.
All surfaces will wear if not cleaned correctly, the only safe way
to clean your mixer tap is to wipe with a soft damp cloth. Stains
can be removed using washing up liquid. All bath cleaning
powders and liquids will damage the surface of your fitting, even
the non-scratch cleaners.
Note: Never use abrasive detergents or disinfectants or those
containing alcohol, hydrochloric acid or phosphoric acid.
Troubleshooting
Symptom
Cause
No flow or
Partially closed isolation valve.
low flow
Instantaneous water heater cycles on
rate
and off as flow rate or pressure is too
low.
Head of water is below the
minimum distance required.
Hot or cold water being drawn off
elsewhere causing pressure changes or
instantaneous boiler temperature
changes.
Air lock or partial blockage in the supply
pipe work.
Water
This is normal for a short time after using
dripping
the taps.
from taps
If water continues to drip,
possibly due to the ceramic disc valves
Taps do not
Closed isolation valve.
turn on
Mains water supply turned off.
3
2.5
mm
Replace the valve into
the body and tighten in
a position. Replace the
handle, tighten the grub
screw and push fit the
cap.
Spare Parts
To replace any spare parts for your
bath shower mixer why not scan
the QR code and search for your
product
Remedy
Open isolation valve.
Increase water flow rate or pressure through system.
2 meters minimum required.
Do not use other water outlets when using the taps.
Flush through pipe work to ensure removal of debris
and any air locks.
This is caused by capillary action, the build up of
water in the tap body.
Remove valves and clean, refer to 'Maintenance'
section before starting any maintenance.
Open isolation valve.
Turn on mains water supply.
Notes
Please use this space for any notes you or your installer may have regarding the installation of this product.
At Bristan, we want to make things as easy as possible for our customers.
That's why we offer solid guarantees on all our products,
effective from the date of purchase, to give you peace of mind.
To start your free guarantee simply scan the QR code and register your product,
alternatively visit www.bristan.com/register.
For any other queries, please call our Customer Service on 03300266273
where our expert team of advisors will be able to offer you any help and advice.
For full guarantee terms and conditions visit www.bristan.com/guarantees.