- ページ 11

バスルーム設備 Bristan 1500のPDF インストール手順とユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Bristan 1500 16 ページ。 Thermostatic power shower

Commissioning - Testing the System

Connect the shower hose to the unit but do not fit the handset.

Turn on the hot and cold isolating valves, and the electricity-

isolating switch. Place the open end of the hose in the bath or

shower tray.

Mixer Valve

Set the temperature control knob to cold, fully clockwise, and press

Spindle

the 'stop/start' button.

Cold water will run from the hose, and you should allow this to

continue for two minutes after which the control knob should be

returned to the '12 o'clock' position. Allow the water to run for a

few minutes to stabilise the hot water flow, and then check that the

water is at a comfortable showering temperature.

If it is too hot or cold, turn off the electricity-isolating switch, pull

off the control knob, and adjust the brass spindle anti-clockwise

to increase the temperature - clockwise to decrease. Replace the

knob in the '12 o'clock' position, switch the electricity on, and check

the water temperature. Readjust as necessary until a satisfactory

temperature is achieved.

Temperature Adjustment

Pass the shower hose through the hole in the soap dish and, using

the rubber sealing washer supplied, fit the handset to the hose and

place the handset in the handset holder.

Press the Stop/Start button. Water flows from the shower head

under the gravity pressure from the storage tank. The 'Eco' button

allows you to switch from a power shower to a gravity (non-powered)

shower.

Temperature Adjustment

The valve allows the maximum showering temperature to be set

at a safe level, preventing accidental scalding. This setting should

be made during commissioning and will require that the hot water

cylinder is at its normal operating temperature.

IMPORTANT:

The handset must be in the spray mode.

We recommend the reading of User Instructions before proceeding

further. This will familiarise you with the operation of the shower.

Turn the brass mixer valve spindle fully clockwise, and then anti-

clockwise until the black line on the spindle is aligned with the

groove on the mixer body, and fit the control knob in the fully cold

position. Check that it is correctly fitted by turning fully clockwise to

the stop, pull the knob off and check that the black line and groove

are aligned. Adjust if necessary. This sets the shower temperature

to 38-40°C, with the control knob pointing to '12 o'clock', if the

stored hot water is at the recommended 60°C.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisors.