- ページ 3

扇風機 Airflow 7106AのPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Airflow 7106A 4 ページ。 Maxair wall exhaust fan
Airflow 7106A にも：保証と取り付け方法 (4 ページ)

ページを印刷する

7106A and 7108A

5. Coil the cut PVC sheet around

the wall grille outlet spigot and

slide into retaining clips.

Sticky

Tape

(optional)

6. Screw wall grille outlet to

external wall (appropriate

fasteners to be used for each

installation not provided).

Internal

Sheet to

be approx.

20mm

overlapping

duct

Fan

Assembly

MaxAir Wall Exhaust Fan Installation Instructions /Warranty Card

7. Place cover assembly, as shown, over fan

Wall Grille

Outlet

Cover

Assembly

WARNING:

The appliance is not intended for use by

young children or inﬁ rm persons unless

they have been adequately supervised by a

responsible person to ensure that they can

use the appliance safely.

Young children should be supervised to

ensure they do not play with the appliance.

Appliance intended to be mounted on

external wall only.

Ensure the fan is switched OFF from the

supply mains before removing the guard.

NOTE: SHUTTER OPERATION

Do not turn auto switched models on

External

without the front cover ﬁ tted. Auto

switched fans are ﬁ tted with a thermal

actuator, thus requiring approximately

three minutes to fully open and

Wall

approximately sixty seconds to close

Grille

shutters. Pull cord models are operated

Outlet

either by the built in pull cord and/or

separate switch (thermal actuator). If it

is decided to use and operate fan via a

separate switch, the delay on opening and

closing of shutters must also be noted.

assembly and tighten retaining screw.

Test. Ready to go.

Retaining

Screw

Fan

Assembly

3 of 4