- ページ 5

エアーコンプレッサー Bristol B SeriesのPDF インストレーション＆サービスマニュアルをオンラインで閲覧またはダウンロードできます。Bristol B Series 18 ページ。 Refrigeration/air conditioning/heat pump compressors

ページを印刷する

CHARGE THE SYSTEM. When a vacuum of at least 200 microns is reached, close gauge valve, remove

vacuum pump, and break the vacuum using system refrigerant vapor. Never dump liquid refrigerant into

the compressor. Liquid can be used to break the vacuum if it is connected to the liquid line, not the

discharge line.

Charge the system according to the manufacturer's specifications. Be sure to compensate the charge for

the addition of the filter drier. Consult unit pressure/superheat chart on the unit door panel for the correct

superheat since pressures and superheat change with the ambient temperature.

WEIGHING in the system charge to the factory specification will help point out system faults that

may still exist.

10.

START-UP. CLAMP-ON AMMETER MUST BE IN PLACE BEFORE POWER IS APPLIED TO MONITOR

START WINDING CURRENT ON START-UP!! See page 6

ASSURE THESE NORMAL START WINDING CURRENTS ON START-UP

CONFIGURATION

NORMAL START WITH RUN CAP ONLY

NORMAL START WITH RUN AND START CAP

NORMAL START WITH START CAP (INDUCTION RUN)

WARNING: If above currents are exceeded for more than 5 seconds, disconnect power and

correct the fault before restarting.

NOTE: Assure voltage to compressor does not drop below minimum allowable voltage (eg. 197

volts for 230/208-1-60) during the period the compressor is trying to start. Refer to page 2

for explanation of test to check LOCKED ROTOR PULL-DOWN VOLTAGE.

2 - 10 AMPS

20 AMPS AND DROP TO 2-10 AFTER START

20 AMPS AND DROP TO 0 AFTER START

Page 5

APPROX. CURRENT