- ページ 10
ストリング・マシン Gamma 5003のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 5003 20 ページ。 6 point mounting
Gamma 5003 にも: オーナーズマニュアル (20 ページ), オーナーズマニュアル (19 ページ), オーナーズマニュアル (20 ページ)
for reduced clamping pressure while securing and holding the string under tension.
STRINGING THE FRAME
Clamp Base Operation
To lock the string clamp base to the turntable,
rotate the clamp base locking lever clockwise.
To release the string clamp base from the
turntable, rotate the clamp base locking lever
counter-clockwise.
The locking lever should be tightened enough
to prevent clamp base slippage on the turn-
table when the desired tension is placed on
the string.
String Clamp Operation
The string clamps are a dual action design
where the string clamp and clamp base oper-
ate independently of one another.
To clamp a string, lift the string clamp, place
the string between the jaws and depress the
string clamp lever to secure the string. The
clamping pressure applied to the string should
be adjusted to provide sufficient pressure
to secure the string when subjected to the
desired pulling tension. The diamond coated
gripper plates provide for increased friction
between the clamps and the string to allow
Clamping the First Main String
To begin stringing the main strings, thread
the two ends of the string through the two
center holes at the appropriate end of the
frame and continue through the opposite
center holes. Thread one end of the string
through the adjacent grommet hole and pull
excess by hand.
Secure one of the strings using a string clamp.
10