- ページ 14

室内暖炉 DecExpert IF-1340のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。DecExpert IF-1340 17 ページ。

ページを印刷する

Touch panel/Remote control Operation

BUTTON

ON: Enables control panel functions and remote

control.Turn on flame effect.

OFF: Disables control panel functions and remote

control.Turn off flame effect.

POWER

Coadl bed COLOR button: Makes the coal bed's color

flame effect changing.

COLOR

FLAME COLOR button: Makes the back flame color

effect changing.

FLAME

HEATER button:Turn heater on and off.

NOTE: To prevent overheating, the heater fan will blow

out cool air for 30 seconds after the heater turn off.

HEATER

TEMPERATURE button: Control temperature settings to

choose temperature as desired.

Setting range from 62F to 82F.

TEMP.

TIMER button: Control timer settings to turn off fireplace

at selected time.

Settings range from 0 hours,1hours, to 8 hours.

TIMER

NOTICE

Temperature Limiting Control

This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature,

the heater will automatically turn OFF. To reset:

1. Unplug the power cord from the outlet.

2. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.

3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,

use a vacuum to clean the vent areas.

4. With the POWER switch in the OFF position, plug the power cord back into the outlet.

5. If the problem continues, have your outlet and wiring inspected by a professional.

FUNCTION

When the heater is first turned on, a slight odor may be odor may be present. This is normal and

should not occur again unless the heater is not used for a long period of time.

To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons

too quickly.Give the unit time to respond to each command.

ACTION&INDICATION

1. Press once. Indicator light turns on. Power turns

on. All functions enabled.

2. Press again. Indicator light turns off. Power

turns on. All functions will off.

1. Press once. Flame color effect gets changing.

2. Press again until desired setting is reached.

1.Press once. Flame color effect gets changing.

2. Press again until desired setting is reached.

1. Press once. Indicator lights up. 750W heater

turns on and blows warm air.

2. Press again. Indicator lights up. 1500W heaters

turns on and blows hot air.

3. Press again. Heaters turn off . The display show

"00"

The fan blows cool air for 30 seconds to allow

heater to cool down, then turns off.

1. Press once. Indicator light turn on. Temperature

is set to 62F.

2. Press again until desired setting is reached. LED

display show setting.

3. Press once. Indicator light turn on. Temperature

is set to hours.

Press again until desired setting is reached. LED

display show setting.