- ページ 16

ストリング・マシン Gamma 5003のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 5003 20 ページ。 6 point mounting
Gamma 5003 にも：オーナーズマニュアル (20 ページ), オーナーズマニュアル (19 ページ), オーナーズマニュアル (20 ページ)

TROUBLESHOOTING TIPS

PROBLEM

String slips in clamps

String slips in gripper

String clamp slips on base

String tension too tight or too loose

For additional assistance, contact Gamma Sports Customer Service at 1-800-333-0337

With time and use, the clamping surfaces of your machine may become oily or dirty and result

in string or clamp slippage while stringing. Periodic cleaning of the following parts is

recommended.

String Clamps

Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner

soaked with isopropyl alcohol between the jaws and rub back and forth. If the build-up is

excessive, dismantle the string clamp jaws to expose the gripping surfaces by removing

the adjustment screw. Using a small nylon brush (such as a toothbrush), a flat sharpening

stone, or an ermery board, scrub the inside surfaces until all debris is removed. Clean the

jaws with isopropyl alcohol and re-assemble.

String Clamp Base

Clean the base of the clamps and the top of the turntable with isopropyl alcohol.

String Gripper

Clean inner gripping surfaces with isopropyl acohol soaked cloth or pipe cleaner. In cases

where there is a lot of build-up, use a flat emery board and scrub the surfaces first.

CARE AND CLEANING

- Adjust gap between jaws

- Clean clamp jaws

- Clean gripper jaws

- Adjust Gripper Jaw Stop Screw

- Clean base of clamp and top of

turntable

- Adjust Clamp Base Locking Nut

- Check tension using a tension calibrator

and adjust calibration if necessary

SOLUTION