- ページ 16

ストリング・マシン Gamma 6004のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 6004 20 ページ。 6 point mounting
Gamma 6004 にも：オーナーズマニュアル (20 ページ), オーナーズマニュアル (20 ページ), オーナーズマニュアル (19 ページ)

MAINTENANCE & ADJUSTMENTS

damages the string, it may be excessively tight and should be adjusted by turning the Adjust-

ment knob counter clockwise to open the gap between the jaws. The clamp jaws should be

cleaned periodically to be free from dirt, oil, and any string coating for them to grip properly.

String Clamp Adjustment

The string clamps will need minor adjust-

ments according to string type, construction,

and gauge.

To adjust the gap (clamping pressure)

between the clamp jaws, insert the string

through the racquet as if you were beginning

the main strings. Clamp the string and pull

tension. If the string slips through the jaws of

the clamp, tighten the clamp by compressing

Adjustment

the clamp jaws together by hand while turn-

Knob

ing the Adjustment Knob, in the clockwise

direction. If the clamp leaves impressions or

Switch Action Clamp Base Adjustment

If the Switch Action clamp bases slip on the

turntable, the base locking levers may need

adjusted. Turn the hex screw clockwise to

tighten the clamp and counterclockwise to

loosen.

remove the adjustment screw and tighten the

two screws underneath of the clamp. Re-install

the adjustment screw.

Switch Action Clamp Base Removal

If the Switch Action clamp base needs to be

removed, undo the 2 screws holding the FRP

stop, underneath of the turntable. Remove

the FRP stop and clamp for cleaning, adjust-

ment or replacement.

If frequent adjustment is needed,