- ページ 12

ストリング・マシン Gamma 6004のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 6004 20 ページ。 6 point mounting
Gamma 6004 にも：オーナーズマニュアル (20 ページ), オーナーズマニュアル (20 ページ), オーナーズマニュアル (19 ページ)

STRINGING THE FRAME

Pulling Tension

Wrap the loose section of string once around the roller

and insert the string between the diamoind dust coated

string gripper plates. Pull the string perpendicular to the

gripper plates while slowly rotating the tensioner crank

clockwise until the brake lever pops out of the latching

block. The string is now tensioned and can be clamped

in place with the remaining fixed clamp.

Repeat the above steps until all main strings are in-

stalled. Tie off ends of main strings as per racquet

manufacturers recommendations.

Clamping the First Main String

To begin stringing the main strings, thread the two ends

of the string through the two center holes at the appro-

priate end of the frame and continue through the oppo-

site center holes. Thread one end of the string through

the adjacent grommet hole and pull excess by hand.

Secure one of the strings using a string clamp.

Pull the remaining end of the string with the tensioner to

the desired tension. Secure the string with the remain-

ing clamp.

Weave the cross strings over and under the main strings

being careful to alternate the weave direction of each

consecutive cross string so as to be opposite of the

previously installed cross string.

Once the final cross string is tensioned and clamped, tie

off at the appropriate hole specified by the racquet

manufacturer.