- ページ 13

ストリング・マシン Gamma 7000 EsのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma 7000 Es 20 ページ。

backwards to release the string. If the string gripper does not rotate back to release the string,

press and hold the Gripper Reversing Switch, located on the end panel. Note : For the Gripper

Returning Switch to function properly, the Tension Switch must be in the tension mode.

Should the Gripper Reversing Switch not seem to function, press the Tension Switch once

and press and hold the Gripper Reversing Switch once again.

STRINGING THE FRAME

Clamping the First Main String

To begin stringing the main strings, insert the

two ends of the string through the two center

holes at the appropriate end of the frame and

continue through the center holes on the

opposite end of the racquet.

Secure one of the strings using a string

clamp and insert the free end into the string

gripper.

Tensioning the First Main String

With the string properly inserted in the string

gripper, and the tensioner speed selected,

press the Tension Switch once and the

string gripper will rotate and slowly apply

tension to the string. When the set tension

has been attained, the gripper will stop

rotating and red LED will go out and the the

green LED turn on. As the tensioned string

stretches, the gripper will rotate intermit-

tently, to maintain the set tension.

To release the string after clamping, press

the tension switch and the gripper will rotate

Tensioning the First Cross String

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.