ページを印刷する
ASSEMBLY INSTRUCTIONS
Installing the Base Legs
A
The PRO 100 is shipped with the legs sepa-
rate from the base and requires assembly
before use.
Hole (A) in the machine base is the attaching
point for the base leg.
Place one screw onto the end of the 4mm
hex wrench. Carefully insert the screw
through the large hole in the bottom of the leg
and continue through the small hole at the
top of the leg.
While holding the leg, screw and wrench as
one unit, place the exposed end of the screw
through hole (A) in the machine base.
Place one washer over the exposed screw
end inside of the machine base. Thread one
locking nut onto the screw end.
2