- ページ 13

ストリング・マシン Gamma PROGRESSION 600ES-LEDのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma PROGRESSION 600ES-LED 17 ページ。

ページを印刷する

1. Features

TROUBLESHOOTING TIPS

PROBLEM

String slips in clamps

String slips in gripper

String clamp slips on base

String clamp winged lock knob is difficult to

turn

Electrical system does not function

String tension too tight or too loose

To change the fuse, remove the power cord and pull the fuse holder straight out. Remove the

old fuse from the holder and replace it with the supplied spare. Replace the fuse holder into

the machine and check for proper operation.

For additional assistance, contact Gamma Sports Customer Service at 1-800-333-0337

With time and use, the clamping surfaces of your machine may become oily or dirty and result

in string or clamp slippage while stringing. Periodic cleaning of the following parts is

recommended.

String Clamps

Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner

soaked with isopropyl alcohol between the jaws and rub back and forth. If the build-up is

excessive, dismantle the string clamp jaws to expose the gripping surfaces by removing the

adjustment screw. Using a small nylon brush, (such as a toothbrush), scrub the inside surfaces

until all debris is removed. Clean the jaws with isopropyl alcohol and re-assemble.

String Clamp Base

Clean the base of the clamps and the top of the turntable with isopropyl alcohol.

String Gripper

Follow the same procedure for cleaning the string clamps.

Fuse Replacement

CARE and CLEANING

SOLUTION

- Adjust gap between jaws

- Clean clamp jaws

- Clean gripper jaws

- Make sure string is wrapped over top

jaw of gripper prior to inserting between

gripper jaws

- Clean base of clamp and top of turntable

- Check for proper position of thrust

bearing in the base of the winged lock

knob

- Check power source

- Check power cord connection

- Check stringing machine fuse

- Call Gamma Sports customer service

- Check tension using a tension calibrator

and adjust machine calibration if

necessary