- ページ 12

ストリング・マシン Gamma PROGRESSION 602のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma PROGRESSION 602 16 ページ。
Gamma PROGRESSION 602 にも：オーナーズマニュアル (12 ページ)

MAINTENANCE & ADJUSTMENTS

or damages the string, it may be excessively tight and should be adjusted by turning the

hex screw counter clockwise to open the gap between the jaws. The clamp jaws should be

cleaned periodically to be free from dirt, oil, and any string coating for them to grip properly.

Note: The string clamps supplied with your stringing machine can accommodate tight string

patterns such as badminton. Depending on the string pattern, the clamp may spread the

strings slightly which will not compromise the quality of the string job.

Adjusting the Turntable Bushings

The turntable bushing is adjusted at the fac-

tory for optimum performance. After time and

use, the turntable bushings may need minor

adjustment. An adjustment is indicated when

noticeable turntable looseness or wobble

occurs while stringing.

To adjust the ﬁ t between the turntable pin

and the bushings, tighten the set screw at the

top of the bushing using a 3mm hex wrench.

Adjusting the Clamp Pressure

The clamps provided with your stringing ma-

chine will need minor adjustments according

to what string type, construction, and gauge

you are using.

To adjust the gap (clamping pressure)

between the clamp jaws, insert the string

through the racquet as if you were beginning

the main strings. Clamp the strings and pull

Adjustment

Knob

tension. If the string slips through the jaws of

the clamp, tighten the clamp by compress-

ing the clamp jaws together by hand while

turning the Adjustment Knob, in the clockwise

direction. If the clamp leaves impressions