- ページ 9

ストリング・マシン Gamma Progression STIIのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Gamma Progression STII 19 ページ。

for increased friction between the clamps and the string to allow for reduced clamping pressure

while securing and holding the string under tension.

Note: If the string slips in the string clamp while tensioning, adjust the gap between the clamp

jaws per the instructions on page 13.

the slot in the clamp base. If the rotation is not sufficient to allow smooth operation of, adjust

the Clamp Base Locking Nut as outlined on page 13.

STRINGING THE FRAME

Clamp Head Operation

Quick Action Clamps are of a dual action

design where the clamp head and clamp

base operate independently of one another.

To clamp a string, lift the clamp head and

place the string between the jaws and de-

press the clamp head lever to secure the

string. The clamping pressure applied to the

string should be adjusted to provide suffi-

cient pressure to secure the string when

subjected to the desired pulling tension.

The diamond coated gripper plates provide

Clamp Base Operation

Rotate the Base Locking Lever clockwise to

secure the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp. The Locking Lever is spring

loaded to assist the unlocking of the clamp

base.

The Locking Lever should be tightened

enough to prevent clamp base slippage on

the turntable, when the desired tension is

placed on the string. To go from the loose

position to the clamped position and back,

generally requires the rotation permitted by

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string

clamp.