- ページ 7

照明器具 Gamma Luxe Bianco 600のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gamma Luxe Bianco 600 10 ページ。 600w led spot with variable white

DMX Setup

DMX512 stands for digital multiplex 512. This means that 512 channels are controlled

digitally through 1 data cable.

A channel is a set of 255 steps that are assigned to control attributes in each light. This may

be a color like red, green or blue, and intensity, strobe, pan/tilt or other attributes.

Multiple sets of 512 "universes" may be used. Only 1 universe will travel on a DMX cable, but

through networked DMX (Art-Net or sACN E1.31), many universes can travel over a network.

DMX works by connecting 1 or multiple lights to the output of a DMX lighting console or

software with a DMX interface.

DMX lights connect in what is called a "daisy-chain". Your first DMX cable will plug it's male

DMX connector into the female DMX connector on your lighting console. The remaining

female connector will then connect to the DMX input on your first light.

You may then connect your next fixture to the output of your first light, and continue the chain.

32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy chain for

signal strength. Sometimes, depending on the fixtures and cable length, this number is less

(or more).

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin only

pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at least 110

ohms resistance. Microphone cable is not DMX cable.

Luxé Bianco 600 (VW)– GAMMA LED Vision

Page 7 of 10