- ページ 6

ミュージックペダル Decibel Eleven Time After TimeのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Decibel Eleven Time After Time 13 ページ。 Fully analog delay pedal

11 o'clock, but the physical FEEDBACK knob is set to 3 o'clock.

In order to quickly find the current preset's settings, the display is used to indicate

knob position. Once a knob starts to rotate, the display will show whether the knob is

set too high or too low, similar to the way an electronic tuner works. The upper line of

the display is lighted if the current knob position is higher than the preset setting, and

the lower line of the display is lighted if the current knob position is lower than the

preset setting. Once the knob position is aligned with the preset setting, the middle line

of the display will light.

Editing a Preset

When turning knobs, the control will not engage until the knob position reaches the

setting of the currently loaded preset. For instance, in the previous example, turning

the FEEDBACK knob will not change the sound until the knob reaches the 11 o'clock

position. Once the FEEDBACK control is engaged, it will behave like an ordinary active

knob. If changes are made to the knob settings from that of the loaded preset, the

yellow PRESET EDITED LED will light.

Saving a Preset

All knob settings can be saved to the current preset number at any time by simply

pressing and holding the DELAY TIME knob for 5 seconds. All of the LEDs will flash to

indicate the preset has been saved.

If a preset is saved with TAP MODE enabled, then tap tempo will be available for the

preset. For example, if a tempo is tapped in while the pedal is bypassed, this saved

preset will then use that tempo when the pedal is enabled (see TAP MODE section on

page 8 for more details).

OPERATING MODES

The Time After Time has up to 11 available user presets. These presets can be loaded

either via MIDI, or by the pedal's footswitches. There are two available modes for

accessing presets with the footswitches. The mode you use will depend highly on your

performance requirements.

PRESET MODE is designed to give the most accessibility to the presets and TAP

MODE functionality. This is the default factory set mode.

In PRESET MODE, the numeric display indicates the actual preset number. The 'B'

footswitch is used to enable or bypass the pedal, and the 'A' footswitch is used to scroll

through the available presets. When the pedal is bypassed, the display will show the