- ページ 4

室内装飾品 IKEA RODULFのPDF マニュアルをオンラインで閲覧またはダウンロードできます。IKEA RODULF 25 ページ。 An electro-mechanically height adjustable work-surface with control interface to adjust height up and down.
IKEA RODULF にも: マニュアル (25 ページ), マニュアル (32 ページ), マニュアル (12 ページ)

IKEA RODULF マニュアル

QUICK GUIDE

Manual reset / first use:

— Perform a reset by simultaneously
pressing the up and down
buttons for at least 8
seconds. Keep holding the
buttons and the desk will
slowly move to the lowest
possible point. Reset is
complete when the desk
has stopped at the lowest
point.
Follow these instructions when
adjusting desk height:
1. Make sure no objects are in the way of the
desk height adjustment range.
2. In order to run the desk up or down, press
the man oeuvre button up or down,
respectively.
— To access full stroke
Release the down button at the lowest safe
point and then press the down button again
for 5 seconds. The desk will move to the
mechanical lowest height to have full stroke
access.

Simple memory

— To set memory/end positions:
Move your desk to the level you want to
store.
Press both buttons three times (0.5-1 second
between each press).
Then press "up" or "down" to set the
position (0.5-1 second).
Do the same for your second stored setting.
Collision detection
— The system is designed to avoid
possible damages to equipment due to
collision.
When desk detects a sudden change in
resistance it will stop the movement and
reverse approximately 50mm. 25mm of
travel to activate in both direction.
Press the up button and
continue to hold until
desired desktop height is
reached.
Press the down button
and continue to hold until
desired desktop height is
reached.

Safety regulations

— When the desk is run up/down, keep
the necessary safety distance to avoid
being trapped between the moving desk
top and fixed objects in the surrounding
area.
— When the desk is run up/down the user
should keep watch so that nobody is
injured or no object is damaged. The desk
top must not bump into a fixed object in
case it overturns. Remove any office chair
before the desk is run up/down, each
time.
— The desk legs must not be altered or
reconstructed in any way. During service
and repair work of the desk, the electrical
cable must always be disconnected from
the wall socket.
— Modifications to the legs are absolutely
prohibited.
— The desk must not be used as a hoisting
device for people.
Maintenance and repair instructions—
After approximately 1 week of use, check
that the screws are properly
tightened.
— If the desk cannot be lowered or raised,
check the connections between the
control box and the wall socket.
— If any part of the electrical system is to be
replaced, the electrical cable must first be
disconnected from the wall socket.
Replace the electrical part and then
reconnect the electrical cable to the
wall socket. The desk is now ready for
use.
If the desk still does not work, please contact
your nearest IKEA store or customer service.
Product servicing
Do not attempt to repair this product
yourself, as opening or removing covers may
expose you to dangerous voltages or other
risks.
Manufacturer: IKEA of Sweden AB Address:
Box 702, SE-343 81 Älmhult, SWEDEN
Telephone no.: +46(0)476-648500
SAVE THESE INSTRUCTIONS
4