- ページ 8

クックトップ KitchenAid Architect Series II KFGS366VSSのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid Architect Series II KFGS366VSS 20 ページ。 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
KitchenAid Architect Series II KFGS366VSS にも：寸法 (1 ページ), 寸法マニュアル (1 ページ)

ページを印刷する

3. Remove surface burner caps and grates from parts package.

Align notches in burner caps with pins in burner base. Burner

caps should be level when properly positioned. If burner caps

are not properly positioned, surface burners will not light.

Place burner grates over burners and caps.

A. Igniter electrode

B. Burner cap

C. Burner base

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

4. Plug into a grounded 3 prong outlet.

Attach Cooktop to Countertop

NOTE: This section applies only if you are using clamping

brackets.

A. Glass cooktop

B. Cooktop base

C. Attachment screw

1. Place the 2½" (6.4 cm) clamping screws into the brackets.

2. Check that the cooktop is still level.

3. Use a flat-blade screwdriver to tighten the screws against the

countertop. Do not overtighten.

D. Clamping bracket (extends far

enough beyond cooktop base

to allow installation of

clamping screws)

E. 2½" (6.4 cm) clamping screw

F. Countertop

Complete Installation

Electronic Ignition System

Initial lighting and gas flame adjustments

Surface burners use electronic igniters in place of standing pilots.

When the cooktop control knob is pushed in and turned to the

"LITE" position, the system creates a spark to light the burner.

This sparking continues, as long as the control knob is pushed in

and turned to "LITE."

Check Operation of Surface Burners

1. Push in and turn the surface burners control knobs to the

"LITE" position.

The surface burner flame should light within 4 seconds. The

first time a surface burner is lit it may take longer than

10 seconds to light because of air in the gas line.

2. Check the flame on HI for a blue color. It should be clean and

soft in character. No yellow tip, blowing or lifting of flame

should occur. Occasional orange flashes are normal and

reflect different elements in the air or gas.

3. Repeat at LO position.

4. After verifying the proper burner operation, turn the control

knobs to OFF.

If burners do not light properly:

Turn surface burner control knob to the OFF position.

Check that the power supply cord is plugged in and the

circuit breaker has not tripped or the fuse blown.

Check that the gas shutoff valves are set to the "open"

position.

Check that burner caps are properly positioned on burner

bases.

Recheck operation of surface burners. If a burner does not light

at this point, turn control knobs to Off and contact your dealer or

authorized service company for assistance.

Adjust Flame Height

The surface burner "low" flame should be a steady blue flame

approximately ¼" (0.64 cm) high.

A. Low flame

B. High flame