スピーカー Majorcom: XS 100T VAのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Majorcom: XS 100T VA 2 ページ。 Compact power speaker 25/50/100w
XS 100T VA
Compact Power Speaker
25/50/100 W
The XS 100T VA is a compact power speaker, with waveguide
•
technology. Whether sports venues, exhibition halls or stages, the
XS 100T VA offers an exceptional sound experience with excellent
speech intelligibility, certified according to EN54-24.
Built in an impact-resistant ABS housing with an aluminium grille,
•
the XS 100T VA is available in white. The 100W speaker is equipped
with two 4'' performance mid-bass woofers, a 2-way bass reflex
system and a high-performance tweeter including a waveguide.
A tweeter switch provides a 4dB boost for possible sound correction
•
in near-wall and near-ceiling installations. The loudspeaker offers
4 different 100V power adjustments. Low-impedance operation is
also possible.
The loudspeaker is weatherproof with IP66 protection rating. A sturdy aluminium bracket ensures flexible mounting,
•
indoors as well as outdoors.
This loudspeaker is also available as a professional line array (XS 100T VA ARRAY).
•
Choose an appropriate mounting position on the wall or ceiling that meets your acoustic requirements. Place the tiltable
1.
metal bracket on the wall or ceiling using suitable mountinghardware. To secure it, use the 3 holes, each with a diameter of
13mm, and 2 holes, eachwith a diameter of 6.5mm, on the metal bracket.
Screws are not included in the delivery. Only use screws that achieve sufficient stability inconjunction with the wall and ceiling
material. Tighten the screws firmly but not excessively toavoid damage.
Attach the speaker to the metal bracket using 2 screws M6x14, along with washers and lockwashers, utilizing the side
2.
cutouts of the metal bracket.
Loosen the 4 screws of the rear terminal cover and remove the cover.
3.
Thread the speaker cable through the PG gland and connect the cable to the screw terminal. Ensure that the cable is
4.
securely and firmly in place to prevent contact issues.
If necessary, make power adjustments on the back of the speaker using the rotary switches. In addition to the 100V
5.
adjustments, operation at 4 Ω impedance is also possible.
Additionally, if needed, you can raise the HF frequency by 4dB using the slide switch.
Place the previously removed terminal cover back onto the speaker and securely tighten thescrews. Ensure that the cover
6.
is firmly in place without any gaps.
To enhance safety, secure the provided steel cable and threadit through the free-threaded hole on the back of the speaker.
7.
Use the provided screw M6x14,a lock washer, and a washer to fasten the steel cable to the speaker. The other end of thesteel
cable should be attached to a stable and secure surface using suitable mounting hard-ware. Ensure that the steel cable is
firmly and stably fixed.
This additional step ensures a secure installation of the speaker and minimizes the risk of un-intended movement or falls.
www.majorcom.fr
FEATURES
MOUNTING INSTRUCTIONS
+33 [0]5 61 31 86 87