- ページ 6
ベビー&幼児用家具 Century Fold n Go Lullaby CenterのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Century Fold n Go Lullaby Center 12 ページ。
5
Insert one side of floorboard
under Pocket on side of
bassinet.
6
Pull Pocket down over
floorboard to hold
floorboard in place.
Repeat steps 5 and 6 for
other side of floorboard.
7
Push down on center of
floorboard to flatten.
Storage Pouch
8
Slide opening in infant canopy
over hooks making sure canopy
goes completely over plastic.
NOTE: Infant canopy attaches
to end of bassinet opposite
storage pouch.
9
Fasten lower snaps on infant
canopy ends to lower snaps
on bassinet.
10
To adjust infant canopy, rotate canopy frame forward or
backward to desired location.
To hold canopy in full forward position, fasten upper snaps
on infant canopy to upper snaps on bassinet.
5
ASSEMBLY and USE continued
Pockets
Bassinet
Pocket
CAUTION:
than 2.3 kg (5 lbs.) in bassinet storage pouch.
Bassinet assembly is now complete.
•
Bassinet can be used with or without changer.
•
Bassinet can be used with or without Playard.
•
Bassinet can be used with or without infant canopy.
To use bassinet with Playard:
1
Place bassinet in Playard so that
hooks go over long rails with
"T-Slots" facing center of
Playard.
NOTE: "T-Slots" MUST face
center of Playard when using
with changer.
2
Secure bassinet to Playard:
• Pass Attachment Strap
through opening in corner
of side panel of Playard.
• Fasten strap to outside of
Playard.
Repeat for other strap.
Bassinet is now ready for use with Playard.
To use bassinet without Playard:
Prevent falls and suffocation:
• Use only on a surface that is flat, level and
stable.
• Keep bassinet away from surface edges.
1
Set bassinet on flat and stable surface that will keep
floorboard level so child will not roll into corner or side of
bassinet resulting in breathing difficulties.
2
Keep at least 30.5 cm (12 inches) away from surface edges
and stay within reach of child. Child's wiggling and rocking
may cause bassinet to move and possibly fall off surfaces.
DO NOT place supplies weighing more
Attachment
Strap
WARNING
"T-Slots"