- ページ 10

農機具 Green Frog Designs Chicken Run 2x2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Green Frog Designs Chicken Run 2x2 17 ページ。

Note: Whilst building, joints should be tapped home

with a wooden or rubber mallet. If you only have a metal

hammer, protect the parts with a piece of wood.

Note: Your layout may differ to the following images

depending on your model. See layout diagrams on

previous pages.

Stand the back wall vertical, and then build and attach

the left side frame using 2m bars, 3-way Corner Joints

and 4-way Edge Joints.

Make sure to slide the 2 Door Hinge Holders (rotated

as shown above) onto the upright from which the door

is to hang, prior to assembling it.

Printed on recycled paper

RUN FRAME ASSEMBLY

Build the back wall using 2m bars, 3-way Corner Joints

and 4-way Edge Joints. Build it flat on the ground, with

the unused lugs facing upwards.

When Electric Fencing is being used, all four Corner

Bar Attachments should be fitted when the frame is

being constructed.

Gradually assemble the rest of the frame one panel at a

time. Middle uprights for the 4x4 and 4x6 runs have 5-

way joints (D) at the top and a Spiked Foot (E) at the

bottom.

The panel with the door should look similar to this. If

Electric Fencing is being used, a Corner Bar

Attachment replaces the lower Door Hinge Holder.

Page 10 of 17