- ページ 3

計測機器 JAMAR Technologies TRAX ApollyonのPDF クイックスタートをオンラインで閲覧またはダウンロードできます。JAMAR Technologies TRAX Apollyon 4 ページ。

Once the data is on the memory stick, you can

move it to your computer. Plug the stick into your

computer, then start TRAXPro. Once in TRAXPro,

select Download Flash Drive from the main menu.

Click Begin Download to transfer the data from the

stick to the computer. Once the download com-

pletes, jump to Step 8.

Downloading directly to a computer with a USB Cable

The TRAX Apollyon can directly download to a computer using a USB cable. Plug one end of the USB cable into the

Apollyon's USB Download Port and the other end into your computer.

Note that the first time you plug the Apollyon into your computer, Windows will detect this new device and you will

get a window for the Found New Hardware Wizard.

the drivers that allow TRAXPro and your Apollyon to communicate.

If your computer has Internet access, select the Install the software automatically option and the driver installation

should begin. Please note that the driver is in two parts. Do not be surprised when the installation finishes and then

immediately appears again. Run through it this second time as well.

If the drivers do not install automatically, or if you run into a problem, instructions for manual installation of the

drivers can be found at www.jamartech.com/installingusbdrivers-apollyon.

Once the Apollyon is connect to the computer

(and the drivers are installed), it's time to start

TRAXPro. Select Download Traffic Recorder

from the main menu, then select Download TRAX

Counter. You can also access this option via File

> Acquire > TRAX/JPDA > Download TRAX

Counter.

Step 8 – Saving Your Data Files

Whether you have downloaded data directly

from the Apollyon, or downloaded it from a

USB Memory Stick, upon completion of the

download you will see a list of count files from

the downloaded data. Click on the one you want,

then click the Process button. You will then be

prompted to assign a file name to the file.

On the download screen you can leave the Baud Rate at the top setting of 115200.

You will need to set the com port to the one assigned during the driver installation. If you are

unsure which com port to use, an easy trick is to check what com ports are listed when the

Apollyon is plugged in and turned on, then unplug the Apollyon and hit Refresh Com Ports.

Look to see what com port disappeared. When you plug the Apollyon back in, and hit refresh,

that same port should reappear. That is the port you want to select.

When the port and baud rate are set, and the TRAX is turned on

and at the main menu, hit Begin. You will see the traffic lights

along the bottom light up in succession, and a blue progress bar

will cross the screen.

Do not ignore this window.

This will walk you through installing