- ページ 13

冷蔵庫 IKEA SUPERKALLのPDF マニュアルをオンラインで閲覧またはダウンロードできます。IKEA SUPERKALL 44 ページ。
IKEA SUPERKALL にも：マニュアル (32 ページ), マニュアル (24 ページ), マニュアル (36 ページ)

ページを印刷する

ENGLISH

Operation

Control panel

Temperature indicator

Function button

Switching on

Warning! Refer to "Electrical

connection" section of the Safety

chapter.

Connect the mains plug to the power socket.

The display on the control panel turns on. To

change temperature, refer to the section for

temperature regulation.

When operating the appliance for the

first time, set the appliance at a colder

temperature and run it without loading any

food until it auto stops at the set temperature.

Usually it takes 2 or 3 hours, then set a desired

temperature and put food in the appliance.

Do not use sharp object to control the touch

panel.

Switching off

• To switch the appliance off, press and hold

the

Function button on the control

panel for 10 seconds. After 30 seconds, the

appliance will switch off all loads are turned

off, and the display and control of the

refrigerator will be all off in the power off

mode.

• To switch the appliance on again, press the

Function button.

To disconnect the appliance from the power

supply, disconnect the mains plug from the

power socket.

Locking/unlocking

• If the door is closed and no button

operation occurs for 30 seconds, the control

panel will be locked. Button operation is

invalid.

• To unlock the control panel, press and hold

the

Function button on the control panel

for 3 seconds. Button operation is available.

Temperature regulation for refrigerator

compartment

• Press the

Function button on the control

panel to toggle a preset temperature.

The four LEDs indicated from ** to *

corresponds to the following temperatures:

2°C, 4°C, 6°C and 8°C. The appliance will run

at the newly set temperature 30 seconds

later.

Adjust the temperature setting by keeping

in mind that the temperature inside the

appliance depends on:

• room temperature

• how often the door is opened

• the quantity of food stored

• the location of the appliance

Important! If the ambient temperature is

high or the appliance is fully loaded, and the

appliance is set to the lowest temperatures, it

may run continuously causing frost to form on

the rear wall. In this case a higher temperature

must be set to allow automatic defrosting and

therefore reduced energy consumption.