- ページ 4
クックトップ KitchenAid KECX160のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid KECX160 6 ページ。 Electric built-in cooktops
ページを印刷する
SECTION D -
INSTALLING
UNIT
Place cooktop in countertop cutout. Center and align unit in opening making sure that required clearances are maintained.
Determine which of the following two mounting methods, shown below in Figures A and B is to be used. When using
either method be sure to use the outermost applicable mounting hole.
NOTE: With some installations, i.e. replacements, it is possible that both methods may be employed.
Hardware for both methods is provided and consists of 4 - wood .screwS and
4
- bolt and clamp assemblies.
WOOD SCREW AND WASHER ASSEMBLY
When permissible the burner box may be fastened directly to the countertop using a wood screw and washer assembly.
Use the cup washer from the bolt and clamp assembly and place wood screw provided through washer.
1. Each unit has double action hinges which allow the front and back mounting holes to be exposed individually. After
centering and aligning unit in cutout, lift cooktop by placing a hand in each front element opening and engage support
rod. See Position 1. Secure burner box using wood screw and washer assembly in front two outermost mounting
holes. As shown in Figure A.
IMPORTANT NOTE: Due to flange design hand tighten only until outer lip is snug to countertop. Overtightening
may
stress flange and cause crazing and chipping of porcelain.
SWITCH
BURNER
BOX
BURNER
BOX
+:\:-.';*
Position
1
Win
2
2. To expose back mounting holes, lift cooktop slightly, disengage support rod and pull cooktop forward, without lowering
it, until hinges lock. Lower cooktop until it rests on countertop. See Position 2. Secure burner box using back two
outermost mounting holes.
3. After fastening lift cooktop slightly and push back. Lower cooktop
into normal position.
CONTINUED
ON PAGE 5
WOOD SCREW
mm-,
COUNTER TOP -,
~
CUP WASHER
II
BURNER BOX
WOOD SCREW AND WASHER ASSEMBLY
Figure A