ページを印刷するMounting set
INFM7X02
__________________________________________________________________________________
Alt.2
Using the adjustment tool that is included in the delivery
of Infinity (not this mounting set), set the angle of the
adaptorbar. Only mount the inner pipe on one side and
then rotate the center pipe to the correct angle. Now
mount the other inne pipe in the same position/angle as
the first one. Check that the center pipe is centered in
the wheelchair. Now tighten the screws in the clamps
(C).
WARNING!
The screws holding the clamps (C)
shall be tightened to 7-9Nm of
torque.
Now read the assembly instructions that was included in the delivery of the Infinity unit.
Assemble and adjust the Infinity according to the instruction.
__________________________________________________________________________________
Sida 7/8