- ページ 9
ホブ IKEA DATIDのPDF マニュアルをオンラインで閲覧またはダウンロードできます。IKEA DATID 24 ページ。 30" (76.2 cm) wall-mount canopy range hood
IKEA DATID にも： ユーザーマニュアル (16 ページ), インストレーション・マニュアル (12 ページ), 取扱説明書 (18 ページ)
ページを印刷する
ENGLISH
What to do if ...
Service instructions
Service and maintenance is only to be
carried out by an authorised person.
To replace parts such as burners, valve
and electric components, the hotplate
must be removed from the bench top by
releasing the attachment hooks, loosening
the attachment screws of each burner,
unscrewing the hotplate attachments nuts
which are visible at the bottom of the
Problem
The electric ignition
does not work
The burner fails to ignite
The gas ring burns
unevenly or flame is not
even.
Possible cause
There is no electrical supply
The gas tap could be closed
- Not pressing down the
ignition knob long enough
- Gas cylinder (liquid gas) is
empty
- Burner openings clogged or
dirty
- Burner parts not positioning
correctly.
- Draughts near the hob
- Minimum gas setting and
injector sizing is incorrect
surface, removing the hotplate top, taking
care to remove lid taps and screws under
them and finally replacing the defective
parts.
Note: If the valves must be replaced, first
disassemble the chain of ignition switches.
It is recommended to replace the valve
gaskets each time the valve is replaced, thus
ensuring a perfect seal between the body
and the gas train.
Solution
Check the unit is plugged in
and the electrical supply is
switched on.
Check that the gas tap is
open
- When lighting the burner,
the knob has been pressed
down for enough time to
allow activating the protection
device.
-Check that the gas or
electrical supplies are not shut
off and especially that the gas
supply tap is open.
- Check that the gas cylinder
(liquid gas) is not empty.
Replace is empty.
- Clean the burner openings
and plug end
- Check all burner parts have
been positioned correctly.
- Check there are no
draughts near the hob.
- Check minimum gas setting
& injector (see relevant
paragraphs)
9