- ページ 6

おもちゃ Century Helicopter Products CN1074AのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Century Helicopter Products CN1074A 15 ページ。

Century Helicopter Products CN1074A マニュアル

Fiberglass Preparation

Prepare the fiberglass, wash all parts in warm water with mild detergent to remove all residue used in the molding

process and let them dry completely. The cabin set can be used as is with the bright yellow gelcoat, simply applying the

decals directly on the fiberglass. Alternately the cabin can be painted to match any existing full scale Bell 47G II or

create your own unique paint scheme.

STEP 1 Cabin Grommets and Inside Mount

Install one rubber grommet into each side of the

cabin. Once installed, apply "Goop" between

the seam and the grommet by lifting the edge

of the grommet and insert the adhesive. The

cabin lights are then bonded directly over the

grommets on the outside of cabin. Carefully

apply adhesive to the edge of the cabin light

and align level, clamp in place until dry.

Using two M3x6 Washer Head Screws

attach the inside mount making sure the

beveled edge is towards the rear.

STEP 2 Windshield

Mark and trim out the windshield. To get a good fit between the windshield and the cabin, the

edges that will mount against the upper door frames need to be bent inwards. Using wide jaw pliers,

grip 1/8" of the edge of the windshield and bent inward. Test fit the windshield, if

it does not "snap fit" into place, repeat the procedure. Install and tape the top and

both sides in the final position. Insert a small part between the bottom of the

windshield and the cabin, opening a 1/8" to 1/4" gap. Apply "Goop" along the

center of the bottom edge, moving the part as adhesive is applied. After 30 minutes

of holding, apply another layer of "Goop" along the edge of the joint to reinforce

it. After 12 hours, remove the tape from one edge and repeat the process to bond

one side. Complete the remaining two edges the same way.

Windshield

[CN1074-2]

Clamping the right side with clothes pin until dry.

Cabin

[CN1074-1]

Rubber

Grommet x 2

[CN1074-7]

Magic

Tape

Mark and trim out each door window. Test fit each

into the matching door, some trimming may be

necessary to get a perfect fit. Apply "Goop" along

the outside edge and press into the door. Clamp for

Door x 2

Window x 2

[CN1074-3]

Bell47G II Detail Manual

Cabin Mount

Hardware

[HI3129C]

STEP 3 Door Windows

12 hours until dry.