- ページ 4
おもちゃ Century Helicopter Products Predator 70のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Century Helicopter Products Predator 70 20 ページ。
ページを印刷する
#CNBB816
#HI6184
Main Blade Grip
Insert one ball bearing into each end of the main blade grip.
Slide the M14 Thrust Washer against the inside bearing.
#HI6181
#HW6180A
Damping
Feathering Spindle
Shims
Slide one large shim against the o-rings followed by three
shims onto the feathering spindle, followed by the blade grip
assembly. Pitch arm is on leading edge. Grease and install the
thrust bearings and secure with the M5x10 socket screw and
washer using threadlock.
#HW6173 Flybar
Pushrod B
26mm (center to
center)
Assemble the flybar, paddles and flybar yoke around the rotor
head and secure with the M4x5 set screws attached from the
top of the arms using threadlock.Adjust pushrod and attach to
from the seesaw to the medium ball on the adjustable side of
4
the bell mixer.
M14 Thrust
Washer
M5x10 Socket
Screw & M5
Flat Washer
#CNBB815T
Bell mixer
assembly
Flybar Yoke
Assembly
HI6179
20gr 3D
Grey
HI6179A 30gr Sport Black 60
7
Attach the seesaw assembly with one M3x18 special socket
screw threaded into the blade grip. Be careful not to over-
tighten the screw.
9
#HI3176C Flybar
Control Yoke
M3x12
Button Head
Screw
M4x5 Set
Assemble each flybar control arm half before it is installed by
threading the double studded ball into the end of the tapered
end of the control arm.
11
#HW6017
Engine Mount
SE-Max
Shims x 8
Before installing the engine, check the gear ratio to determine
the correct number of shims to install between the mounting
lugs on the engine and the engine mount.
M3x18 Special Socket
Shoulder Screw
#HW6001
#CNLR1014
Short Ball
Screw
Gear Ratio
9.0:1
9.3:1
8.18:1
8.45:1
8
#CNLR1020
Medium
Ball
10
Pushrod A
47mm (center
to center)
M4x6
Washer
12
Kit
# Shims
60 & SE
4
3
Max
1
Max
0
M4x16 Socket
Screw