- ページ 3

IPアクセスコントローラ Gantner GAT Access 6600 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Gantner GAT Access 6600 Series 4 ページ。 Access control terminal with rfid and barcode

ページを印刷する

Mounting and installation instructions

In order to mount the GAT Access 6600 onto a turnstile, a tubular

mounting holder with 30 mm Ø is used (e.g., a GAT Holder 6010 L). The

connecting cables are fed through the tubular holder and into the housing.

Opening the housing

The housing of the GAT Access 6600 must be opened to install the tubular

holder. Unscrew and remove the 4 housing screws on the rear part while

firmly holding the front part of the GAT Access 6600 to prevent it from

falling. After the screws are removed, the front part can be lifted away.

Two clamps inside the housing are used to fasten the tubular holder. The

lower clamp (1) is directly accessible and can be loosened accordingly to

allow the tubular holder to be inserted.

In order to gain access to the second clamp (2), the electronics (3) must

be removed. Loosen the two screws as indicated in the figure below (4)

and swing the electronics 90 ° forward (5).

www.gantner.com

Attachment of the tubular holder and cable installation

Insert the GAT Access 6600 onto the tubular holder (7) until the stop (6)

is reached.

Tighten the screws of the two clamps (1) + (2) firmly so that the GAT

Access 6600 is secure and cannot be removed from the tubular holder.

Feed the connecting cables through the tubular holder. Connect the

cables to the screw terminals (see next page). Use cable ties to secure

the cabling to the holes provided in the retaining strip (8).

Remount the electronics in their original position and fasten the 2 screws

(4). Take care not to damage the connecting cable.

Close the housing by placing the front part of the housing onto the

rear part and secure them with the 4 screws. Take care to ensure the

housing gasket is correctly inserted into the joint between the front

and rear part and not damaged during this process.

Valid as from June 16

2015 • Technical data subject to modifications without notice!

DB_GAT-ACCESS6600--EN_11.indd • PartNo.: 822630