- ページ 10

おもちゃ Century UK Neon Blaze CP V2.4GのPDF ユーザーハンドブックマニュアルをオンラインで閲覧またはダウンロードできます。Century UK Neon Blaze CP V2.4G 18 ページ。

Gyro sensitivity and Rudder Mixing adjustment

You can adjust the gyro sensitivity and Rudder Mixing adjustment after locking the PIT parameters. The methods are shown as follows:

1. Turn the No.12 DIP switch to "ON" position, aim the V1、V2 knob on the transmitter panel to "0" position.

2. The V1 knob on the transmitter panel rotating towards "+" end increases the gyro sensitivity, and rotating towards "-" end decreases the

gyro sensitivity.

3.The V2 knob on the transmitter panel rotating towards "+" end increases the Rudder Mixing, and rotating towards "-" end decreases the

Rudder Mixing, the maximum value is 30%.

4. Turn the knob V1 towards "+" end to the "70 " position, the gyro sensitivity is about "70

position, the Rudder Mixing is about "-20

5. After the adjustment is finished, turn the No12 switch to "OFF" position. that is to lock the regulated gyro sensitivity and Rudder Mixing parameter.

The purpose of adjusting the main rotor blade is to correctly set up the collective pitch

and to assure the main rotor blades are spinning at the same horizontal level.

1. Color decal. Two different colored blade tracking decals should be stuck on each blade

tip (Fig. 11, red and blue).

2. Main rotor blade inspection. The purpose of inspecting the two blades is to keep

them symmetrical in weight and shape. Connect the two blades to inspect (Fig. 11).

3. Blades tracking adjustment. Before checking the blades tracking, please properly install

the battery pack and initiate the gyro. Note the red stick on one blade tip. Place your

helicopter on the reasonable level so that you can view the blades at your eye level.

Please make sure you are at a safe distance away from the high spinning blades.

If the red blade is higher than the other one, please lengthen the the ball linkage of the

other blade in one or more turn increments; otherwise, please shorten its length.

The blades tracking and vibration will arise from looseness and/or distortion of the blade

connector. If the blade connector is loose or distorted, please adjust or substitute a new

connector for the old one.

Tail Rotor Blade Adjustment

1. Tail rotor blade inspection. ① Check whether the tail gear and the tail motor gear are

properly meshing. ② Check whether the tail rotor blades are fixed well (Fig. 13).

2. Tail rotor blade adjustment. ① If the tail gear and the tail motor gear are not properly

meshing, unscrew the fixing screws and adjust the tail motor to the optimal position, and

then tighten the fixing screws. ② If the tail rotor blades are not fixed well, adjust the screw.

Main Rotor Blade Adjustment

"; Turn the knob V2 towards "-" end to the "-20 "

Fig. 11

Fig. 12

Fig. 13

Red

Blue

Main rotor

blade

Blade holder

Ball linkage

Tail rotor blade

Fixing screw

Tail motor

Tail motor gear

Tail gear

Screw