- ページ 4

タッチターミナル Gantner GAT ACCESS 6100のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gantner GAT ACCESS 6100 4 ページ。 Access control terminal

ページを印刷する

Electrical connections

TCP/IP with external power supply

GAT Access 6100

Network

Ethernet, Connection via screw terminals.

Power supply

DC supply (see technical data), e.g. via GANTNER GAT Power Supply

SP014/1. The power input is protected against reverse-polarity.

Recommended cables:

Ethernet: min. CAT 5 (STP) for 100 MBit

Wire colours

Ethernet 10/100 MBit

568A

568B

TX +

green/white

orange/white

TX -

green

orange

RX +

orange/white

green/white

RX -

orange

green

Connection to the device upper part

Attention: The socket (3) for the connection cable between the device

back part and the device upper part must be clean in order to guarantee

a good contact.

Valid as from July 30

, 2013 • Technical data subject to modifications without notice!

DB_GAT-ACCESS6100--EN_11.indd • PartNo.: 860279

Power supply unit

e.g. GAT Power Supply SP014/1

TCP/IP

Relay output

For activation of devices like turnstiles etc.. The relay contact is of type

NO (maker contact). Please observe the max. permitted switching voltages

and currents (see technical data).

Depending on the connected instalation (e.g. turnstile) an additional free-

wheeling diode may be necessary, which is used to limit the switch-on

current. Please read the documentation of the connected installation.

Optocoupler input

Input for status acquisition. For using the input a supply voltage must be

applied. This voltage can be taken from the terminal's supply or from an

external power source. Please observe the max. permitted input voltages

and currents (see technical data).

Mains power

Motor control

Feedback control

Safety instructions

- This device must be installed by qualified personnel only.

- The applicable safety and accident prevention regulations

must be observed.

- Safety devices must not be removed.

- Please observe the technical data of the device specified

on the data sheet.

- The device must be disconnected from the power supply

prior to installation, assembly or dismantling.

e.g. Turnstile