- ページ 15

ホブ IKEA Lagan HGA4KのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA Lagan HGA4K 24 ページ。 Ikea hobs instruction manual
IKEA Lagan HGA4K にも：ユーザーマニュアル (16 ページ), 取扱説明書 (24 ページ), ユーザーマニュアル (28 ページ), 取扱説明書 (20 ページ), 取扱説明書 (16 ページ)

ページを印刷する

ENGLISH

The minimum distance to be maintained

from cut out edge to lateral wall must be

100 mm.

If there is no oven beneath the hob insert a

dividing panel at a minimum distance of 20

mm from the bottom of the hob.

Protect the cut surfaces of the worktop

against moisture using a suitable sealant

included in the product in fitting bag. The

sealant seals the appliance to the worktop

with no gap. Do not use silicon sealant

between the appliance and the worktop.

Avoid installing the appliance next to doors

and under windows as hot cookware may

be knocked off the pan support when doors

and windows are opened.

Gas Connection

Warning! Only a qualified

person must install this

appliance.

Warning! This appliance is not

connected to a combustion

products evacuation device.

Installation must comply with current local

regulation. The connection of the cooktop to

the gas pipe network or gas cylinder must

be made by means of a rigid copper or

steel pipe with fittings complying with local

regulations, or by means of a continuous

surface stainless steel hose complying with

local regulations.

If you see any abnormalities do

not repair the pipe, contact local

After Sales Service (refer to the

Service chapter).

The connection must be installed correctly,

fixed into hob connection pipe. Otherwise it

will cause leakage of gas.

Warning! Once the installation is

complete, check the perfect seal

of every pipe fixing. Use soapy

water, never flame.

Electrical connection

Before connecting, check that the nominal

voltage of the appliance stated on the

rating plate, corresponds to the available

supply voltage. Also, check the power

rating of the appliance and ensure that the

wire is suitably sized to suit the appliance

power rating (refer to the Technical data

chapter).

Electrical Requirements

Permanent electrical installation must

comply with the latest I.E.E. Regulations and

local Electricity Board regulations. For your

own safety the installation must be done by

a qualified electrician (e.g. your local

Electricity Board, or a contractor who is on

the roll of the National Inspection Council

for Electrical Installation Contracting

[NICEIC]).

The manufacturer declines any

liability if these safety measures

are not observed.

The appliance must be connected to a

220-240 V 50/60 Hz AC electrical supply.