- ページ 8

コントロールユニット Bernard Controls BTのPDF スタートアップマニュアルをオンラインで閲覧またはダウンロードできます。Bernard Controls BT 12 ページ。 Separated box

5.2 Installing cable glands



Procedure is the same for connection compartment and connector.

How to install cable glands

For each cable entry used

1. Remove plug from the cable

entry (M20 entry for control

or M25 entry for power) with

the adjustable wrench.

2. Separate sealing nut from

its cable gland.

3. Screw and tighten cable

gland in the cable entry.

4. Thread the sealing nut on

the cable and pass the cable

through the cable gland.



Unused entries must be kept closed by their plugs as they are part

of the components allowing actuator IP68 protection setting.

Crimping the wires

Terminal plate is fitted with tab terminals,

compatible with 6.35mm crimp receptacle lugs

with insulated funnel.

These lugs allow wire section between 1.5 and

2.5mm².

 Once cables are installed in the cable glands, crimp end of

every wire to be connected with a lug.

English