- ページ 9

換気フード IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOODのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD 44 ページ。 30" (76.2 cm) wall-mount canopy range hood

ページを印刷する

Install Range Hood

1. Remove screws from wooden shipping supports. Properly

dispose of shipping materials.

2. Using 2 or more people, hang range hood on 2 mounting

screws through the mounting slots on back of hood.

A. Mounting screws

B. Mounting slots

C. Lower mounting screws

D. Optional wall anchors (if needed)

3. Remove the grease filter. See "Range Hood Care" section.

4. Level the range hood and tighten upper mounting screws.

5. Install 2 - 5 x 45 mm #2 Phillips lower mounting screws and

tighten. (Use optional wall anchors if needed.)

Connect Vent System

1. Install transition on top of hood (if removed for shipping) with

2 - 3.5 x 9.5 mm T10 sheet metal screws. Use T10 Torx

(or T10 adapter provided) to tighten.

A. Vent transition

B. 3.5 x 9.5 mm screw

For vented installations only:

1. Fit vent system over the exhaust outlet.

2. Seal connection with clamps.

3. Check that back draft dampers work properly.

drive

For non-vented (recirculating) installation only:

1. Assemble the air deflector with the duct cover bracket using

4 - 4.2 x 8 mm T20

screws. Use T20

adapter provided) to tighten.

A. Assembly screws

B. Air deflector

C. Duct cover bracket

2. Measure from the bottom of the air deflector to the bottom of

the hood outlet.

A. Air deflector

B. Vent clamp

C. X = length to cut vent duct

3. Cut the duct to the measured size (X).

4. Remove the air deflector.

5. Slide the duct onto the bottom of the air deflector.

6. Place the assembled air deflector and duct over the exhaust

outlet from the hood.

7. Reassemble the air deflector to the duct cover bracket with

the 4 assembly screws.

8. Seal connections with vent clamps.

Torx

drive (or T20

D. Vent duct

E. Exhaust outlet