- ページ 14

ヘッドセット CeoTronics CT-DECT GateCom Headset StandardのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CeoTronics CT-DECT GateCom Headset Standard 20 ページ。 Headset for wireless duplex communication

ページを印刷する

Headset with exchangeable headset muff

General

This headset model is equipped with an exchangeable right headset muff where the rechargeable

battery is located. When the battery is discharged the right headset muff can be exchanged easily by a

headset muff with charged battery. This allows the headset to be used while recharging the battery.

Exchange of headset muff

Switch off the headset. Loosen the screw connection (Fig. 5/a) in the connection cable to the right

headset muff and disconnect the plug connection. On the right headset muff pull the head band

(Fig. 5/b) out of the head band holder (Fig. 5/c) until the end stop. On the inner side of the head band

holder is a retaining clip (Fig. 5/d). Use your thumb-nail or a small screwdriver to press the retaining clip

away from the head band. While depressing the retaining clip, pull off the headset muff from the head

band. Reassemble the spare headset muff equipped with a recharged battery in reverse order.

Headset muffs for helmet fastening

The two headset muffs can be supplied without a head band for lateral fastening to a helmet. Different

fastening parts are available depending on the helmet type. Separate installation instructions are

available for fastening to the helmet, these being provided together with the delivery of the fastening

parts. Lay the connection cable between the two headset muffs in the helmet so that it causes no

annoyance. In addition you can also use the head strap (see section 3.2).

If no noise protection is required for the activity, you can fold the two fastening arms with the headset

muffs outwards and away from the helmet.

10.

Headset with microphone socket

This headset (example Fig. 10) is equipped with a 5-pin microphone socket (Fig. 10/a). Depending on

the usage requirements a pluggable CT microphone, e.g. a gooseneck microphone or a throat

microphone, can be connected to the microphone socket.

Example throat microphone – Connect the throat microphone with the microphone plug (Fig. 10/b) to

the microphone socket (Fig. 10/a). Place the harness (Fig. 10/c) of the throat microphone around the

neck and position the microphone (Fig. 10/d) on the throat.

Safekeeping – storage

11.

Store the cleaned device in a clean, dry place at normal room temperature and in normal relative air

humidity.

12.

Recharging the batteries

WARNING

Never use battery chargers to charge non-rechargeable batteries. Never open rechargeable

batteries or throw them into fire. Used (defective) rechargeable batteries are subject to special

waste disposal. Do not put them in the household refuse!

Use a CeoTronics charger (see section 14) to charge the 3.6 V/2300 mAh NiMH rechargeable battery

or the optional 3.6 V/2300 mAh Li-Ion rechargeable battery in the headset. Using other chargers can

cause rechargeable batteries to become damaged. The battery charging socket (see example Fig. 7/a)

is located on the right-hand headset muff. Notice the special CeoTronics operating instructions for the

charger.

CAUTION

To recharge the battery always switch off the headset.

14 von 20