- ページ 10

換気フード IKEA IH6242SM0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA IH6242SM0 28 ページ。 60 cm (23 3/5") wall-mount canopy range hood

ページを印刷する

For non-vented (recirculating installations,

install charcoal

filter over grille on blower housing and turn filter handle

clockwise.

Repeat with other charcoal filter.

.......................

A. Blower housing

B. Filter handle

C. Charcoal filters

2. For all installations,

insert back edge or metal filter into rear

channel of the filter opening.

3. Push handle toward the rear and push filter up.

4. Pull filter toward the front and insert into front channel.

...... _ o1_ ®0123 {_

.....

A. Light switch

B. Blower switch

1. Move the light switch to "1" position. The light should turn on.

2. Move blower switch to "1" position. The blower should

operate.

3. Move the blower speed switch to "1" position for low speed,

"2" position for medium speed or "3" position for high speed.

4. Move blower and light switches to "0" position to turn off

blower and light.

5. If range hood does not operate, check to see whether a

circuit breaker has tripped or a household fuse has blown.

6. Disconnect

power supply.

7. Check that the wiring is correct.

8. Replace all parts and panels before operating.

9. Reconnect power.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.

RANGE HOOD USE

The canopy hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

Hood control panel

The hood controls are located on the front side of the canopy.

........ S

Operating

the light

1. Move the light switch to the "1" position to turn on the light.

2. Move the light switch to the "0" position to turn off the light.

Operating

the blower and adjusting

blower speed

1. Move the blower switch to the "1" position for low speed, the

"2" position for medium speed or the "3" position for high

speed.

2. Move the blower switch to the "0" position to turn off the

blower.

A. Light switch

B. Blower switch