- ページ 5
クックトップ KitchenAid KGCV465MSS03のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。KitchenAid KGCV465MSS03 20 ページ。 36" pro line series commercial style cooktop
ページを印刷する3=proagground=type outlet
should he lauated on left hand
side of cutout 8" 20,3 am)
max=from eric aaare s dewa .
Gas supply line should be
located in this area on rear or
side wails, at the supply line can
came up through the floor,
Gas and Electric
Connection
Locations
Note: Solid sideand
bottomofcataot
enclosure n at shown,
product rating/serial tag
control sopt_t
panel
regulator (
with product) mast be
installed with arrow up
pointing at cooktop
bottom
I/2"nipple
(not supplied)
AGA orUSA approved
flexible stainless
steam gassupplyline
(not supplied)
shut off valve
(not supplied)
36" (91,4 am)
3-prong ground-type
power supplycard
Typical
Gas
and
Electric
Connections
Copies of the standards listed may be
obtained from:
* USA hternationat
8501 East P_easant Valley Rd.
C_eveJand, Ohio 44t31-8875
Explosion
Hazard
Use a new AGA or USA approved
gas supply
line.
Install a shut-off
valve.
Securely tighten
alt gas
connections.
Ifconnected to LP,have a qualified
person
make sure gas pressure
does not exceed 14" water column.
Examples
of a quatified
person
include:
licensed heating
personnel;
authorized
gas company
personnel;
and
authorized
service
personnel
Failure to do so can result in death,
explosion,
or fire.
Observe aH governing
codes and
ordinances,
important:
Cooktop must be connected
to a regulated gas supply,
installation must conform with
local codes and ordinances, in the
absence of local codes, installations must
conform with American National
Standard, National Fuel Gas Code
ANSI Z223.1 -- latest edition or
CANI -- B149.1 or 2".
E input ratings shown on the
model/serial rating plate are for elevations
up to 2,000 feet (610 m). For elevations
above 2,000 feet (610 m), ratings are
reduced at a rate of 4% for each 1,000
feet (305 m) above sea level
C
EThe cooktop is equipped for use
with Natural gas. it is design=certified by
CSA International for Natural and LR
gases with appropriate conversion. The
model/serial rating plate, located on the
underside of the burner box, has
information on the type of gas that can be
used. if this information does not agree
with the type of gas available, check with
the local gas supplier.