- ページ 12

換気フード IKEA IHW8303WS0のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。IKEA IHW8303WS0 32 ページ。 30"(76.2cm) wall-mount canopy range hood
IKEA IHW8303WS0 にも：取扱説明書 (28 ページ)

ページを印刷する

RANGE HOOD USE

RANGE HOOD CARE

The range hood is designed to remove smoke, cooking vapors

and odors from the cooktop area. For best results, start the hood

before cooking and allow it to operate several minutes after the

cooking is complete to clear all smoke and odors from the

kitchen.

Range Hood Control Panel

The range hood controls are located on the underside of the

canopy.

,23

......

ooo

A. Light button

B. Indicator lights

C. Speed button

Operating

the light

1. Press the "A" button to turn on the light.

2. Press the "A" button again to turn off the light.

Operating

the blower and adjusting

blower speed

1. Press the "C" button for low, medium and high speed.

2. Press and hold the "C" button for more than 2 seconds to

turn off the blower.

IMPORTANT: Clean the hood and grease filter frequently

according to the following instructions.

Replace grease filter

before operating hood.

Be sure lights are cool before cleaning the hood.

Exterior Surfaces

Clean the range hood with a mild detergent and soft cloth. To

avoid damage to the exterior surface, do not use abrasive

cleanser or steel-wool pads.

Metal Grease Filter

The filter should be washed frequently. Place metal filter in

dishwasher or hot detergent solution to clean.

Drain water through edge holes and let the filter dry thoroughly

before replacing it.

To Remove

Metal Grease Filter

1. Turn off blower and lights. Check that halogen lamp is cool.

2. Remove the front panel by extracting it outwards.

3. Push handle toward the rear and pull downward.

4. Pull filter toward the front.

To Replace Metal Grease Filter

1. Insert back edge of filter into rear channel of the filter

opening.

2. Push handle toward the rear and push filter up.

3. Pull filter toward the front and insert into front channel.

4. Refit the front panel so that all the fixing pins enter inside

slots on range hood body, press with force and check that

panel is firmly fixed in place.